Structure and characteristics of the basic parameters 

 First, the model: non-standard build 

 Second, heating 

 ● ● oil gas heating heating steam heating ● ● ● infrared electric heating, etc. 

 Second, the temperature control system: 

 1, temperature range: room temperature -50-2000 degrees (can be freely set the required temperature) 

 2, temperature controller: The RKC 70 temperature controller, LED digital display make setting, PID auto-calculation correction settings, with seven core and contact thermocouple temperature control output and to ensure more stable and more accurate. 

 3, temperature control accuracy: ± 1% ℃ 

 4, the temperature uniformity: ± 2 ℃ (heating air furnace in the next test) 

 Third, the transport air control system: 

 1, transport wind turbine: Taiwan to strengthen axis bending Guanhua oven for motor strength and configuration of multi-wing Lingnan style licensing round. 

 2, mode of air transportation: a special duct design, wind power, low noise; temperature distribution of particularly good; in the furnace or so up and down both sides of the force of the wind, surrounded by the return air circulation. Configuration adjustment board in the air, adjusting the furnace temperature. Configuration in the furnace at the top of the chimney to vent exhaust products in the baking, the time the smoke emissions. 

 Fourth, the furnace structure and materials: 

 1, the box is 1.2mm thick galvanized sheet or 304 # stainless steel, sealed around the TIG process. 

 2, outside the box with 1.5mm thick A3 iron or 304 # stainless steel, sealed around the TIG process. 

 3, insulation materials: use of high environmental temperature CSR 100K cotton insulation thickness of 80mm, thermal insulation and excellent efficiency, energy saving 30% less than conventional electricity oven, 

 4, door seals: high temperature resistant silicone durable forced tightly sealed 

 Sixth, security decency: 

 1, over-temperature alarm device, (over-temperature when the heating power off the alarm, warning lights and buzzer) 

 2, the motor phase current protection device (motor overload cut off the heating power to prevent a bad baked products) 

 3, the control circuit short circuit and overload protection, when a short circuit or other fault cut off the power to protect the electrical safety). 

 Seven machine works: 

 1 to start the power flower off → 2, open the motor transportation wind switch → 3, turn the heating switch → 4, set the desired temperature → 5, start heating → 6, the temperature began to automatically calculate the baking time to reach → 7, to reach the baking time Start Beeper, and cut off the heating power.